Table of Contents
Advertisement
Installing the Switch on a Concrete Wall
This section contains the instructions for installing the switch on a concrete
wall. Please review the information in the following sections before
performing the procedure:
"Switch Orientations on a Wall" on page 80
"Installation Guidelines" on page 81
Warning
The device is heavy. Always ask for assistance before moving or
lifting it to avoid injuring yourself or damaging the equipment.
Warning
The device should be installed on the wall by a qualified building
contractor. Serious injury to yourself or others or damage to the
equipment can result if it is not properly fastened to the wall.
E105
To install the switch on a concrete wall, perform the following procedure:
1. Place the switch on a table.
2. Install four wall/equipment rack brackets to the sides of the unit with
the sixteen M4x6mm screws included with the switch. Refer to Figure
7 on page 85.
3. After attaching the brackets, have another person hold the switch on
the concrete wall at the selected location for the device while you use a
pencil or pen to mark the wall with the locations of the four screw holes
in the four brackets (one screw per bracket). Refer to Figure 9 on page
88.
Please follow these guidelines as you position the switch on the wall:
Position it so that the front panel is facing left or right. Refer to
Figure 5 on page 80. Do not install the switch with the front panel
facing up or down.
Provide sufficient space from other devices or walls so that you can
access the front and back panels, and for adequate air flow and
ventilation.
x530DP Series Installation Guide for Standalone Switches
87
Advertisement
Table of Contents
