Installing The Switch On A Din Rail; Figure 15: Orientation Of The Switch On A Din Rail - Allied Telesis AT-IE300-12GP Installation Manual

Chapter 3: Installing the Switch

Installing the Switch on a DIN Rail

The switch comes with a DIN rail bracket pre-installed on the back panel.
The bracket is compatible with DIN 35x7.5mm rails. Figure 15 shows the
proper orientation of the switch on a DIN rail. Do not install the switch
horizontally or upside-down.
Figure 15. Orientation of the Switch on a DIN Rail
To install the switch on a DIN rail, perform the following procedure:
1. Slide the slot on the top of the DIN rail bracket onto the top edge of the
DIN rail. Refer to Figure 16 on page 65.
64