Table of Contents
Advertisement
Installing the Switch on a Concrete Wall
This section contains the instructions for installing the switch on a concrete
wall. Please review the information in the following sections before
performing the procedure:
"Switch Orientations on a Wall" on page 58
"Installation Guidelines" on page 59
Warning
The device is heavy. Always ask for assistance before moving or
lifting it to avoid injuring yourself or damaging the equipment.
Warning
The device should be installed on the wall by a qualified building
contractor. Serious injury to yourself or others or damage to the
equipment may result if it is not properly fastened to the wall.
E105
To install the switch on a concrete wall, perform the following procedure:
1. Place the switch in a table.
2. Install the wall/equipment rack brackets to the sides of the unit with the
M4x6mm screws included with the switch. Refer to Figure 27 on page
64 and Figure 28 on page 65.
3. Have another people hold the switch on the concrete wall at the
selected location for the device while you use a pencil or pen to mark
the wall with the locations of the screw holes in the brackets (one
screw per bracket). Refer to Figure 30 on page 68.
Please follow these guidelines as you position the switch on the wall:
Position the switch so that the front panel is either on the left or the
right. Refer to Figure 24 on page 58. You may not install the switch
with the front panel facing up or down.
Leave sufficient space from other devices or walls so that you can
access the front and back panels, and for adequate air ventilation.
x220 Series Installation Guide
67
Advertisement
Table of Contents
