Installing The Switch On The Plywood Base; Figure 21: Installing The Wall Brackets On The Switch - Allied Telesis AT-IE300-12GP Installation Manual

Installing the
This procedure assumes that the plywood base for the switch is installed
on the wall. Please review "Reviewing Safety Precautions" on page 52 and
Switch on the
"Reviewing Site Requirements" on page 57 before performing this
Plywood Base
procedure.
To install the switch on the plywood base, perform the following procedure:
1. Place the switch on a table.
2. Install the two wall brackets to the back panel of the switch, with the
The selected wall location for the base should adhere to the

recommendations in "Reviewing Site Requirements" on page 57.
Warning
The device is heavy. Always ask for assistance before moving or
lifting it to avoid injuring yourself or damaging the equipment.
Warning
The device should be installed on the wall by a qualified building
contractor. Serious injury to yourself or others or damage to the
equipment may result if it is not properly fastened to the wall.
four screws included with the unit. Refer to Figure 21.
Figure 21. Installing the Wall Brackets on the Switch
IE300 Series Installation Guide
69