Table of Contents
Advertisement
Installing the Switch on a Concrete Wall
This section contains instructions on how to install the switch on a
concrete wall.
Here are the tools and material required for installing the switch on a
concrete wall:
Two wall brackets (included with the switch)
Four bracket screws (included with the switch)
Four wall screws (not provided)
Cross-head screwdriver (not provided)
Drill and 1/4" carbide drill bit (not provided)
Four anchors and screws for attaching the switch to the wall (not
provided). The diameter of the screw holes in the wall brackets is
4.5 mm (0.17 in.).
To install the switch on a concrete wall, perform the following procedure:
1. Place the switch in a table.
2. Install the two brackets that come with the switch to the back panel of
the unit. Refer to Figure 21 on page 65.
3. Hold the switch on the concrete wall at the selected location for the
device and use a pencil or pen to mark the wall with the locations of
the four screw holes in the wall brackets. Refer to Figure 23 on page
68.
Please follow these guidelines as you position the switch on the wall:
The switch must be oriented as shown in Figure 23 on page 68.
You may not install the switch horizontally or upside-down.
Be sure to leave sufficient space from other devices or walls to
allow for adequate air circulation around and through the cooling
fins. Refer to "Reviewing Site Requirements" on page 55 for further
information.
IE200 Series Installation Guide
67
Advertisement
Table of Contents
