Figure 33: Securing The Grounding Wire To The Switch - Allied Telesis AT-IE300-12GP Installation Manual

Chapter 5: Powering On the Switch
86
4. Tighten the screw to secure the grounding wire to the switch. Refer to
Figure 33.
Figure 33. Securing the Grounding Wire to the Switch
5. Connect the other end of the ground wire to a ground point at the
installation site.
6. Do one of the following:
To wire the alarm connectors, go to "Wiring the ALM IN and ALM

OUT Connectors" on page 87.
Otherwise, go to "Preparing the DC Power Cables" on page 92.
