Table of Contents
Advertisement
Chapter 3: Installing the Switch
Installing the Switch on a DIN Rail
The switch comes with a DIN rail bracket pre-installed on the back panel.
The bracket is compatible with DIN 35x7.5mm rails. Figure 17 shows the
proper orientation of the switch on a DIN rail. Do not install the switch
horizontally or upside-down.
Figure 17. Orientation of the Switch on a DIN Rail
To install the switch on a DIN rail, perform the following procedure:
1. Slide the slot on the top of the DIN rail bracket onto the top edge of the
DIN rail. Refer to Figure 18 on page 63.
62
Advertisement
Table of Contents
