Bluetooth Beep And Led Indications; Easy Pairing And Auto-Reconnect - LXE MX7 Tecton CE Reference Manual

Bluetooth Beep and LED Indications

Bluetooth Beep and LED Indications
Beep Type from Bluetooth Device
Acknowledge label
Label rejected
Transmission error
Link successful
Link unsuccessful
LED on Bluetooth Device
Yellow LED blinks at 2 Hz
Off
Yellow LED blinks at 50 Hz
Yellow LED blinks at the same rate as the paging beep (1 Hz)
Green LED blinks once a second
Upon startup, if the scanner sounds a long tone, this means the scanner has not passed its automatic Selftest and has entered
isolation mode. If the scanner is reset, the sequence is repeated. Contact your
for assistance.

Easy Pairing and Auto-Reconnect

The Bluetooth module can establish relationships with new devices after the user taps the Discover button. It can auto-
reconnect to devices previously known but which have gone out of range and then returned within range.
Note: Configuration elements are persistent and stored in the registry.
Setup the Bluetooth module to establish how the user is notified by easy pairing and auto-reconnect events.
AppLock, if installed, does not stop the end-user from using the Bluetooth application, nor does it stop other Bluetooth-enabled
devices from pairing with the MX7 Tecton while AppLock is in control.
E-EQ-MX7CERG-A [ 114 ] MX7 Tecton™ CE Reference Guide
Behavior
1 beep
2 beeps at low frequency
Beep will sound high-low-high-low
Beep will sound low-medium-high
Beep will sound high-low-high-low
Behavior
Linking in progress
Disconnected or unlinked
Bluetooth transmission in progress
Paging
Disabled indication
LXE representative or LXE Customer Support