Options - LXE MX7 Tecton CE Reference Manual

Options

Options
Option
Report when connection
lost
Report when reconnected
Report failure to reconnect
Computer is connectable
Computer is discoverable
Prompt if devices request to
pair
1
Personal Aea Networking profile. Un-modified Ethernet payloads (using BNEP) can exchange packets between Bluetooth
devices. PANU is a PAN User service that uses either the NAP or the GN service.
1
Dial-Up Networking provides access to the Internet and other dial-up services using Bluetooth technology.
1
Human Interface Device profiles used by Bluetooth keyboards, mice, pointing devices and remote monitoring devices.
This option is Enabled by default.
There may be an audio or visual signal when a connection between a paired, active device is
lost.
A visual signal may be a dialog box placed on the display notifying the user the connection
between one (or all) of the paired Bluetooth devices has stopped. Tap the ok button to remove
the dialog box from the screen.
This option is disabled by default.
There may be an audio or visual signal when a connection between a paired, active device is
re-connected.
A visual signal may be a dialog box placed on the display notifying the user a connection
between one (or all) of the previously paired Bluetooth devices is complete. Tap the ok button
to remove the dialog box from the screen.
This option is Enabled by default.
The default time delay is 30 minutes. This value cannot be changed by the user.
There may be an audio or visual signal when a connection between a paired, active device fails
to re-connect. A visual signal may be a dialog box placed on the display notifying the user the
connection between one (or all) of the previously paired Bluetooth devices has failed.
Tap the X button or ok button to close the dialog box.
Possible reasons for failure to reconnect: Timeout expired without reconnecting; attempted to
pair with a device that is currently paired with another device; attempted to pair with a known
device that moved out of range or was turned off; attempted to pair with a known device but the
reason why reconnect failed is unknown.
This option is Enabled by default.
Disable this option to inhibit MX7 Tecton connection initated by a Bluetooth scanner.
This option is Disabled by default.
Enable this option to ensure other devices can discover the MX7 Tecton.
This option is Disabled by default.
A dialog box appears on the MX7 Tecton screen notifying the user a Bluetooth device requests
to pair with the MX7 Tecton.
The requesting Bluetooth device does not need to have been Discovered by the MX7 Tecton
before the pairing request is received.
Tap the Accept button or the Decline button to remove the dialog box from the screen.
Note: In some cases, if a Bluetooth device is already paired this setting cannot be
changed. If this is the case, an error message is displayed and the option is not changed.
The Bluetooth device must be disconnected before changing this setting.
E-EQ-MX7CERG-A [ 106 ] MX7 Tecton™ CE Reference Guide
Information