Centering; Decodemode - LXE MX7 Tecton CE Reference Manual

Centering

Centering
Start | Settings | Control Panel | Data Collection | HHP Properties button
The centering feature is used to allow the user to accurately scan a selected barcode among a group of barcodes that are
located closely together. When centering is turned on, the imager will only decode barcodes that intersect the centering
window defined by the user. The centering window must intersect the center of the barcode.
The default centering settings define a 60 pixel square area in the center of the imager's field of view.
Default centering settings and allowable minimum and maximum settings are listed below.
Centering
Default
Valid
Enable or disable Centering feature. When disabled, the following values are ignored.
Position
CenteringTop
CenteringBottom
CenteringLeft
CenteringRight

DecodeMode

Start | Settings | Control Panel | Data Collection | HHP Properties button
Default 1
Valid 1 = Normal mode
2 = Aggressive Linear Decode (ALD)
4 = Quick Omni
In Normal mode the imager will decode both linear and 2-D symbologies.
In Aggressive Linear Decode mode the imager will only read linear symbologies in this mode, but decoding these is faster and
more accurate than Normal Mode.
In Quick Omni mode the imager searches for a barcode in a reduced field located around the center of the image. Decoding is
faster in this mode, but the user must center the aiming line over the barcode to be read. Both linear and 2-D symbologies can
be read in this mode.
Enable
0
1 Enable
0 Disable
Default
120
360
188
564
E-EQ-MX7CERG-A [ 166 ] MX7 Tecton™ CE Reference Guide
Minimum Maximum
0 239
240 479
0 319
320 639