Reflash The Mx7 Tecton; Introduction; Reflashing And Language Options; Preparation - LXE MX7 Tecton CE Reference Manual

Reflash the MX7 Tecton

Reflash the MX7 Tecton

Introduction

Depending on the size of the operating system, the total time required for successful reflashing may require several minutes.
The OS upgrade files are unique to your MX7 Tecton's physical configuration and date of manufacture. OS upgrade files
designed for one device configuration should not be used on a different device configuration. The SD Flash card must be
formatted as FAT and be less than 1GB.

Reflashing and Language Options

Note: If the image to be updated is a non-English Language image (48M), check the Non- English checkbox before
updating to a Simplified Chinese, Traditional Chinese, Korean or Japanese version of the OS. The update process may
take between 6 and 10 minutes when Non-English is checked. The Non-English checkbox is greyed when the Update is
processing.
Same Language to
Same Language
Change Language
during Reflash
Process

Preparation

Contact your LXE representative
l
LXE recommends that removal or installation of the SD Flash card be performed on a clean, well-lit surface.
l
Always perform MX7 Tecton updates when it has a fully charged main battery and/or a dependable external power
l
source connected to the MX7 Tecton and a fully charged internal battery.

Procedure

Place new image files on a SD card.
Place the MX7 Tecton in Suspend Mode and remove the main battery pack.
Lift the rubber barrier and slide the SD card out of the slot. Do not remove the rubber barrier.
During the reflash process all settings revert to factory defaults. Parameters will need to be changed
from factory defaults to your preferred values at the conclusion of the reflash process.
When changing from one language to another during the reflash process, all files in the System
folder will be deleted as the system is repartitioned and all system settings are cleared. Parameters
will need to be changed from factory defaults to your preferred values at the conclusion of the reflash
process.
to get the OS Upgrade files from LXE.
Flash Disk Location
E-EQ-MX7CERG-A [ 42 ] MX7 Tecton™ CE Reference Guide
Update Icon