Barcode Readers; Return To Factory Default Settings - LXE MX7 Tecton CE Reference Manual

Barcode Readers

Barcode Readers
Your MX7 Tecton may be using any of the following barcode readers:
Short Range Laser Scanner, 955I
l
Low Power Scanner, 955E (see Note)
l
Multi-Range "LORAX" Laser, 1524ER
l
or a Hand Held Products 2D Area Imager, 5300.
Note: Low Power Scanner, 955E does not support aim mode. Any attempt to adjust the aiming beam using SE955
programming barcodes will fail. The Low Power scanner does not decode Codablock, Code93i, Matrix 2 of 5 or Telepen
symbologies.
Tethered scanners (LXE 8500 series tethered to a serial port on the device or cradle) are configured by
scanning the engine-specific barcodes in the scanner manufacturer's programming guide. The man-
ufacturer's guides are usually shipped with the barcode reader.
LXE wireless Bluetooth 8700 and 8800 series are configured by scanning the engine-specific barcodes in
the scanner manufacturer's programming guide. The manufacturer's guides are usually shipped with the
barcode reader.
The LXE Bluetooth Ring Scanner (8650) module may be using a Symbol SE4400 Ring Imager or a Sym-
bol SE955 Ring Scanner. The BTRS module is configured by scanning the barcodes in the Bluetooth Ring
Scanner Guide.

Return to Factory Default Settings

After scanning the engine-specific barcode to return the scanner/imager to factory default settings, the next step is to open
Start | Settings | Control Panel | Data Collection on the mobile device collecting the scanned data. Click the OK button and
close the control panel. This action will synchronize all scanner formats for your device.
Engine specific barcodes are contained in the Integrated Scanner Programming Guide. They can be used to set or reset scan
engine parameters by scanning a barcode, then saving the change. Symbol scan engines can be programmed using
programming barcodes.
The HHP 5300 Imager engine is programmed by using the HHP Properties button on the Data Options tab and the Advanced
button available on many of the individual Symbology Settings screens to configure the HHP Imager engine. There are no
configuration barcodes for the HHP Imager.
E-EQ-MX7CERG-A [ 118 ] MX7 Tecton™ CE Reference Guide