Icom IC-2820H Instruction Manual page 8

QUICK REFERENCE GUIDE
D Using the mounting bracket
qDrill 4 holes where the mounting bracket is to be installed.
• Approx. 5.5–6 mm (
when using self-tapping screws.
wInsert the supplied screws, nuts and washers through the
mounting bracket and tighten.
eAdjust the angle for your suitable position.
Nut
Spring washer
When using
self-tapping
screws
Flat washer
25˚
III
") when using nuts; approx. 2–3 mm (
1
⁄
4
Mounting nut
D Controller/Separation cable connection
Two connection cables, conteoller cable
")
1
⁄ gle body installation and separation cable
8
mote installation,
Connect the controller and the main unit using with the sup-
plied connection cable as follows.
Controller
Mounting
6-pin connector
bracket
IMPORTANT!— number of pin
Number of pin, between both side connectors of the connec-
tion cable are different— one side is 6-pin, other side is 4-pin.
You should connect the 6-pin connector to the main unit, and
the 4-pin connector to the controller.
(10 cm; 3.9 in)
(3.4 m; 11.2 ft) for re-
are supplied with the IC-2820H.
Main unit
4-pin connector
for sin-