Icom IC-2820H Instruction Manual page 56

5
MEMORY OPERATION
D Programming a memory channel via the microphone
The microphone can also be used to program mem-
MW
ory channels.
z Set the desired frequency in VFO mode.
➥ Push [VFO/LOCK] to select VFO mode.
➥ Set the frequency using the keypad.
➥ Set other data
audible tone encoder ON/OFF and its frequency)
sary.
x Push [MR/CALL] to enter memory mode.
c Push [
C(T-OFF)], then set the desired memory chan-
ENT
nel using the keypad.
[EXAMPLE]: Programming 145.870 MHz into memory channel 20 (blank channel) via the microphone.
Push ,
39
(e.g. offset frequency, duplex direction, sub-
Push
"
"
Beep
"
Beep
"
Beep
"
v Push [VFO/LOCK] to select VFO mode.
b Push [FUNC] then push and hold [
program.
➥ 3 beeps may sound and the VFO contents
, if neces-
subaudible tone frequency, etc.)
➥ Memory channel number increases when continuing to
push [
MR/
Push
CALL
"
Beep
Push then for 1 sec. and continue to push
CLR
are programmed.
A(MW)] after programming.
CLR
then Push
➠
"
Beep
A(MW)] for 1 sec. to
(including the