Memory Operation; I General Description; I Memory Channel Selection - Icom IC-2820H Instruction Manual

5

MEMORY OPERATION

I General description

The transceiver has 522 memory channels including 20 scan
edge memory channels
of these channels can be individually programmed with oper-
ating frequency
(pgs. ??–??)
, subaudible tone encoder or tone squelch and its tone
(p. ??)
frequency
(pgs. ??, ??, ??, ??)
In addition, a total of 26 memory banks, A to Z, are available
for usage by group, etc.

I Memory channel selection

D Using the tuning dial
[M/CALL•MW]
[DIAL]
åXßappears
37
, and 2 call channels. Each
(10 pairs)
, duplex direction and offset
(p. ??)
and skip information*
(p. ??)
*except for scan edge memory channels.
q Push the desired band's
[M/CALL•MW]
times to select memory
mode.
• "X" indicator appear
w Rotate the same band's
[DIAL] to select the de-
sired memory channel.
• Programmed
channels only can be se-
lected.
D Using the [Y]/[Z] keys
z Push [BAND] to select the desired band as
MR/CALL
x Push [MR/CALL] to select memory mode.
c Push [Y] or [Z] to select and set the desired
Y/Z
.
D Using the keypad
z Push [BAND] to select the desired band as
MR/CALL
x Push [MR/CALL] to select memory mode.
several
c Push [
Y/Z
v Push 3 appropriate digit keys to input a chan-
memory
the main band.
memory channel.
• Pushing and holding [Y]/[Z] for 1 sec. activates
a scan.
• If scan is activated, push [Y]/[Z] again or push
[ A(MW)] to stop it.
CLR
the main band.
C(T-OFF)] to activate the keypad
ENT
for numeral input.
nel number.
• Blank channel can be selected.
• Push only 1 appropriate digit key, [
9(16-KEY-L)]] then push [M M (TONE-1)]
2)] to [
SIMP
or [ #(16KEY-L)] to select scan edge chan-
Z
SQL
nels. "M M " and "#" can be used for "A" and "b" re-
spectively.
0(TONE-
Y
VOL