Configuring Channel-Zero Encoding - HIKVISION DS-9608NI-I8 User Manual

Network Video Recorder User Manual
Step 1 Go to System > Live View > General.
Step 2 Set the video output interface, Live View mode, and dwell time.
Step 3 Go to View Settings to set the view layout.
Step 4 Click OK to save the settings.

6.6 Configuring Channel-Zero Encoding

Purpose
Enable channel-zero encoding when you need a remote view of many channels in real time
from a Web browser or CMS (Client Management System) software, in order to decrease the
bandwidth requirement without affecting the image quality.
Step 1 Go to System > Live View > General.
Step 2 Set the video output interface to Channel-Zero.
Step 3 Go to System > Live View > Channel-Zero.
Step 4 Check the Enable Channel-Zero Encoding checkbox.
Step 5 Configure the Frame Rate, Max. Bitrate Mode, and Max. Bitrate. The higher frame rate
and bitrate settings result in higher bandwidth requirement.
Step 6 Click Apply.
Result: You can view all of the channels on one screen using the CMS or a Web browser.
UM NVR v4.xx 111717NA
Video Output Interface: Select the video output interface.
Live View Mode: Select the display mode for Live View, e.g., 2*2, 1*5, etc.
Dwell Time: The time in seconds to wait between switching of cameras when in
auto-switch. The range is from 5s to 300s.
Figure 6-6 Live View, Channel-Zero Encoding
53