Network Video Recorder User Manual
12.8.3 Notifying Surveillance Center
The device can send an exception or alarm signal to the remote alarm host when an
event occurs. The alarm host refers to the PC installed with client software (e.g.,
iVMS-4200, iVMS-5200).
Step 1 Go to System > Network > Advanced > More Settings.
Step 2 Set the alarm host IP and alarm host port.
Step 3 Go to the Linkage Action interface of the alarm detection (e.g., motion
Step 4 Select the Notify Surveillance Center.
12.8.4 Configuring E-Mail Linkage
The system can send an e-mail with alarm information to a user or users when an
alarm is detected. Refer to Chapter 16.7 Configuring E-Mail for details of e-mail
configuration.
Step 1 Go to System > Network > Advanced.
Step 2 Configure the e-mail settings.
Step 3 Go to the Linkage Action interface of the alarm detection (e.g., motion
Step 4 Select the Send Email alarm linkage action.
12.8.5 Triggering Alarm Outputs
The alarm output can be triggered by alarm input, motion detection, video tampering
detection, face detection, line crossing detection, and any other event.
Step 1 Go to the Linkage Action interface of the alarm input or event detection (e.g.,
Step 2 Click the Trigger Alarm Output tab.
Step 3 Select the alarm output(s) to trigger.
Step 4 Go to System > Event > Normal Event > Alarm Output.
Step 5 Select an alarm output item from the list.
UM NVR v4.xx 111717NA
detection, video tampering, face detection, etc.).
detection, video tampering, face detection, etc.).
motion detection, face detection, line crossing detection, intrusion detection,
etc.).
Refer to Chapter 12.6.3 Configuring Alarm Output for the alarm output settings.
123