HIKVISION DS-9608NI-I8 User Manual page 133

Network Video Recorder User Manual
Step 2 Click Region Exiting.
Step 3 Select a camera to configure.
Step 4 Check Enable Region Exiting Detection.
Step 5 Optionally, check Save VCA Picture to save the captured region exiting detection
pictures.
Step 6 Follow these steps to set the detection rules and detection areas.
1) Select an Arming Region to configure. Up to four regions are selectable.
2) Drag the sliders to set Sensitivity.
Sensitivity: The higher the value, the more easily the detection alarm will be triggered.
Its range is [0-100].
3) Click Draw Region and draw a quadrilateral in the preview window by specifying
Step 7 Set the arming schedule. Refer to Chapter 12.1 Configuring Arming Schedule.
Step 8 Set the linkage actions. Refer to Chapter 12.2 Configuring Alarm Linkage Actions.
Step 9 Click Apply.
UM NVR v4.xx 111717NA
Figure 13-6 Region Exiting Detection
four vertices of the detection region.
132