HIKVISION DS-9608NI-I8 User Manual page 5

Network Video Recorder User Manual
Safety Instructions
Proper configuration of all passwords and other security settings is the responsibility of the
installer and/or end-user.
In the use of the product, you must be in strict compliance with the electrical safety
regulations of the nation and region. Refer to technical specifications for detailed information.
Input voltage should meet both the SELV (Safety Extra Low Voltage) and the Limited Power
Source with 100 to 240 VAC or 12 VDC according to the IEC60950-1 Standard. Refer to technical
specifications for detailed information.
Do not connect several devices to one power adapter as adapter overload may cause
overheating or a fire hazard.
Make sure that the plug is firmly connected to the power socket.
If smoke, odor, or noise rise from the device, turn off the power at once, unplug the power
cable, and then contact the service center.
Preventive and Cautionary Tips
Before connecting and operating your device, be advised of the following tips:
Ensure unit is installed in a well-ventilated, dust-free environment.
Unit is designed for indoor use only.
Keep all liquids away from the device.
Ensure environmental conditions meet factory specifications.
Ensure unit is properly secured to a rack or shelf. Major shocks or jolts to the unit as a result of
dropping it may cause damage to the sensitive electronics within the unit.
Use the device in conjunction with a UPS if possible.
Power down the unit before connecting and disconnecting accessories and peripherals.
A factory recommended HDD should be used for this device.
Improper use or replacement of the battery may result in hazard of explosion. Replace with the
same or equivalent type only. Dispose of used batteries according to the instructions provided
by the battery manufacturer.
Product Key Features
General
Connectable to network cameras, network domes, and encoders
Connectable to third-party network cameras, including ACTI, Arecont, AXIS, Bosch, Brickcom,
Canon, Panasonic, Pelco, Samsung, Sanyo, Sony, Vivotek, Zavio, and cameras that adopt the
ONVIF or PSIA protocol
Connectable to smart IP cameras
H.265+/H.265/H.264+/H.264/MPEG4 video formats
PAL/NTSC adaptive video inputs
Each channel supports dual streams
Up to 8/16/32/64 network cameras can be added according to model
Independent configuration for each channel, including resolution, frame rate, bit rate, image
quality, etc.
The quality of the input and output record is configurable
UM NVR v4.xx 111717NA 4