Network Video Recorder User Manual
1.2 IR Remote Control Operations
The device may be controlled with the included IR remote control, shown in Figure 1-5.
Batteries (2 × AAA) must be installed before operation.
The IR remote control is set at the factory to control the device (using default Device ID# 255)
without any additional steps. Device ID# 255 is the default universal device identification number
shared by the devices. You may also pair an IR remote control to a specific device by changing the
Device ID#, as follows:
Pairing (Enabling) the IR Remote Control to a Specific Device (optional)
You can pair an IR remote control to a specific device by creating a user-defined Device ID#. This
feature is useful when using multiple IR remote controls and devices.
On the NVR:
Step 1 Go to System > General.
Step 2 Type a number (255 digits maximum) into the Device No. field.
On the IR Remote Control:
Step 1 Press the DEV button.
Step 2 Use the number buttons to enter the Device ID# that was entered into the device.
Step 3 Press the Enter button to accept the new Device ID#.
UM NVR v4.xx 111717NA
18