Configuring Recording Schedules - HIKVISION DS-9608NI-I8 User Manual

Network Video Recorder User Manual
Step 4 Click OK to save the settings.

8.4 Configuring Recording Schedules

The camera automatically starts/stops recording according to the configured schedule.
Before You Start
Make sure you have installed the HDDs in the device or added the network disks before you
attempt to store video files, pictures, and log files.
Refer to the
Network Disk for network HDD connections.
Step 1 Go to Storage > Recording Schedule.
Step 2 Select a camera.
Step 3 Check Enable Schedule.
Step 4 Select a Record Type. The record type can be Continuous, Motion Detection, Alarm,
Motion | Alarm, Motion & Alarm, or Event. Different recording types are configurable.
UM NVR v4.xx 111717NA
Post-record: The time set to record after the event or scheduled time. For
•
example, if an alarm triggered recording ends at 11:00, and the post-record
time is 5 seconds, the device will record until 11:00:05.
Expired Time: The period of time for a recorded file to be kept in the HDD.
•
When the deadline is reached, the file will be deleted. If the expired time is
set to 0, the file will not be deleted. The actual keeping time for the file
should be determined by the HDD capacity.
Redundant Record/Capture: Enable redundant record or capture to save the
•
record and captured picture in the redundant HDD. See
Redundant Recording and Capture
Stream Type: Main stream and sub-stream are selectable for recording.
•
Select sub-stream to record for a longer time with the same storage space.
Quick Start Guide
for HDD installation instructions. Refer to Chapter 8.1.2 Adding
Continuous: Scheduled recording
Event: Recording triggered by an event triggered alarm
Motion: Recording triggered by motion detection
Alarm: Recording triggered by an alarm
M/A: Recording triggered by either motion detection or an alarm
M&A: Recording triggered by motion detection and an alarm
POS: Recording triggered by POS and an alarm
Chapter Configuring
.
72