Attaching The Electrode Stand - Thermo Scientific Orion Versa Star Pro User Manual

Thermo Scientific

Attaching the Electrode Stand

The electrode stand can be attached to either side of the meter and up to two stands can be
attached to each meter. A weighted base (Catalog Number STARA-HB) is also available to
support the stand without a meter.
1. Open the box containing the stand. Included are base plate, electrode arm, pivot pin,
electrode holder, ATC spacer and RDO clip.
2. Turn the meter over, with the meter display facing down, on a clean dry surface.
3. Identify the side of the meter that the stand will be installed on and remove the screw
between the circles on that side of the meter.
4. Align the base plate of the stand with the circles on the meter.
5. Replace the screw from step 3 to attach the base plate to the meter.
6. Turn the meter over, with the meter display facing up.
7. Insert the electrode arm into the metal post on the base plate.
8. Connect the electrode holder to the electrode arm using the pivot pin.
9. Once the stand has been assembled, use the two wing nuts to adjust the tension at each
joint to restrict the movement forward and backward using the lower wing nut and upward
and downward using the upper wing nut.
ATC Spacer
RDO Clip
Electrode Holder
Cable Management Clips
Pivot Pin
Electrode Arm
Base Plate

Chapter 2 Meter Basics
Upper
Wing Nut
Lower
Wing Nut
Orion Versa Star Pro Meter User Manual

9