Table of Contents
Advertisement
Maintenance Schedule
Section 9
Cleaning the Sample Flow Chamber
It is recommended that you inspect the sample flow chamber at least once a year to check for
any flow blockage, and to inspect the operation of the float level sensor. The sample chamber is
located on the right lower corner of the fluidics enclosure.
The chamber can be removed for service and clean up.
Figure 14: Sample chamber detail
Stand-By Mode and Extended Shutdown
To put the System in Stand-by mode, make sure to press the STOP key and check the
DISPLAY field next to F4 to show MANUAL RESTART. If AUTO RESTART is selected, you
need to set the mode to Manual:
MENU ➔ SETUP ➔ + ANALYSIS PARAMETERS ➔ MODE
2230XP Silica Analyzer
Thermo Scientific Orion
71
Advertisement
Table of Contents
