Chapter 5; Conductivity Measurement Module; Connecting Electrodes To The Module - Thermo Scientific Orion Versa Star Pro User Manual

Chapter 5


74 Orion Versa Star Pro Meter User Manual
5

Conductivity Measurement Module

Connecting Electrodes to the Module

To begin using the Versa Star Pro meter and module system, prepare the meter and insert the
module into an available channel on the back of the meter. See
instructions. For information on customizing meter settings, refer to
 It is recommended that electrodes be placed in the meter-attached electrode stand for easy
movement in and out of beakers during calibration, sample measurement and storage.
VSTAR-CND Versa Star Conductivity Module
8 pin MiniDIN
1. Connect a conductivity probe to the 8 pin MiniDIN connector on the module. If the
conductivity probe has a built-in temperature probe, the temperature will also be measured
when the conductivity probe is connected.
2. Prepare the conductivity probe for use as instructed in the probe user manual.
Chapter 2 Meter Basics for
Chapter 3 Setup Menu.
Thermo Scientific