Table of Contents
Advertisement
CDM-625 Advanced Satellite Modem
Remote Control
Command
Parameter
Number of
(Instruction
Type
Arguments
& Qualifier)
EDMAC Slave
ESA=
4 bytes
Address
Range
Engineering
ESC=
1 byte, 0 or 1
Service
Channel
Description of Arguments
Command or Query.
EDMAC Slave Address Range - sets the range of addresses of
distant-end units (modems or transceivers) that this unit, as the
Master, will forward messages for. Only values which are integer
multiples of ten are permitted. (0010, 0020, 0030, 0040 etc.)
Example: ESA=0090
This command is only valid for an EDMAC master. When used as a
Query, it may be sent to an EDMAC slave, which will respond with
the appropriate address.
Command or Query. (IBS and ESC++ feature)
Format:
ESC=x
where: x = 0 (Disable the high-rate ESC)
x = 1 (Enable the high-rate ESC)
IBS ESC may only be enabled when:
1.
Both Tx and Rx framing modes are set to IBS.
2.
Data rate is not 1544 kbps (as spare overhead bits are not
available in this mode).
3.
IBS high-rate ESC FAST option is enabled.
D–26
MN-0000036 (Ref MN/CDM625.IOM)
Query
Response to
(Instruction
Response to Query
Command
& Qualifier)
ESA=
ESA?
ESA=xxxx
ESA?
(see description of
arguments)
ESA*
ESA#
ESC=
ESC?
ESC=x
ESC?
(see description of
arguments)
ESC*
ESC#
Revision 1
Advertisement
Table of Contents
