Config | Lnb (Low Noise Block Down Converter) - Comtech EF Data CDM-625 Installation And Operation Manual

CDM-625 Advanced Satellite Modem
Ethernet Management
6.5.4.3.7

Config | LNB (Low Noise Block Down Converter)

The 'Config | LNB' page (Figure 6-12) is used to configure Low Noise Block Down Converter
parameters, and display the LNB status for L-Band operation.
LNB Control
• LNB DC Power and LNB Reference Enable may be turned ON or OFF.
• The user may assign LNB Low and High Current Threshold values ranging from 0 to
500 mA.
• The user may assign the Rx Lockout Frequency and designate the value as a HIGH (+)
or LOW (-) limit.
LNB Status
The parameters shown here are read-only and cannot be changed.
Once the desired configuration settings have been made on this page, the user should then click
[Submit LNB Controls] as needed to save those changes.
Figure 6-12. Config | LNB page
6–20
MN-0000036 (Ref MN/CDM625.IOM)
Revision 1