Technical Specifications; Cp3002-Hdd Module Specifications - Kontron CP3002 User Manual

CP3002-HDD
A.2

Technical Specifications

Table A-1: CP3002-HDD Module Specifications
CP3002-HDD
Serial Port
USB
DVI-D
SATA
CFast
Board-to-Board
HDD LED
Front Panel Switch
Power Consumption Power consumption without hard disk, CFast card and peripheral devices connected:
Temperature Range Operational:
Climatic Humidity
Dimensions
Board Weight
Battery
Page A - 4
One 16C550-compatible serial port (COMA), RS-232; 9-pin D-Sub connector; J5
Two USB 2.0 connectors, J2 and J4
One DVI-D connector with digital signals only, J1
SATA connector, J3, for connecting a SATA 2.5" HDD/SSD
One CFast card socket, J6
One high-speed I/O extension connector, J7, for connecting the module to the
CP3002
One LED (green) monitors SATA activity
Reset button, guarded
100 mA at 3.3 V
0°C to +60°C
Storage: -55°C to +85°C
-40°C to +65°C
Note ...
When a battery is installed, refer to the operational specifications
of the battery as this determines the storage temperature of the
CP3002-HDD module (See "Battery" below).
93% RH at 40°C, non-condensing (acc. to IEC 60068-2-78)
Dimensions: 100 mm x 158 mm
482 grams (8 HP CP3002 with CP3002-HDD, heat sink, front panel, two 2 GB
SODIMM memory modules and battery, but without CFast card and 2.5" HDD/SSD)
3.0V lithium battery for RTC with battery socket. Recommended type: CR2025
Temperature ranges:
Operational: -20°C to +70°C
Storage: -55°C to +70°C
SPECIFICATIONS
Standard
Without hard disk and without battery
With hard disk
typical (refer to the battery manufacturer's specifica-
tions for exact range)
typical (no discharge)
CP3002
ID 1042-9252, Rev. 2.0