C. Sata Flash Module - Kontron CP3002 User Manual

CP3002
C. SATA Flash Module
The 4HP CP3002 provides an optional SATA Flash module with up to 16 GB NAND Flash
memory. The SATA Flash module is connected to the CP3002 via the board-to-board
connectors J5 located on the CP3002 and J1 located on the SATA Flash module. The SATA
Flash module has been optimized for embedded systems providing high performance,
reliability and security. The SATA Flash module cannot be used in conjunction with the
CP3002-HDD module.
Note ...
Write protection is available for this module. Contact Kontron for further assis-
tance if write protection is required.
Note ...
If the SATA Flash module is mounted on the CP3002, the CP3002-HDD mod-
ule cannot be used on the CP3002.
Either the SATA Flash module or the CP3002-HDD module can be mounted
on the CP3002.
C.1 Technical Specifications
Table C-1: SATA Flash Module Specifications
SATA FLASH MODULE
Board-to-Board Connector
Memory
Power Consumption
Temperature Range
Climatic Humidity
Dimensions
Board Weight
ID 1042-9252, Rev. 2.0
SPECIFICATIONS
One 18-pin, female, board-to-board connector, J1
Up to 16 GB SLC-based NAND Flash memory
Built-in full hard disk emulation
•
Up to 50 MB/s read rate
•
Up to 45 MB/s write rate
•
typ. 0.5 W
3.3 V supply
Operational: 0°C to +60°C
-40°C to +85°C
Storage: -40°C to +85°C
93% RH at 40°C, non-condensing (acc. to IEC 60068-2-78)
38 mm x 27 mm
ca. 7 grams
SATA Flash Module
Standard
Extended
Page C - 3