CP3002
3.5.5
CFast Card Installation
The 8HP CP3002 equipped with the CP3002-HDD module provides a CFast card socket with
ejector. For further information regarding the CP3002-HDD module, refer to Appendix A in this
manual.
Note ...
The CP3002-HDD does not support removal and reinsertion of the CFast stor-
age card while the board is in a powered-up state. Connecting the CFast card
while the power is on, which is known as "hot plugging", may damage your sys-
tem.
3.5.6
Rear I/O Device Installation
For physical installation of rear I/O devices, refer to the documentation provided with the device
itself.
Note ...
VGA and Ethernet can be used either on the front panel or on the rear I/O.
COMA can be used either on the 8HP expansion module or on the rear I/O. It
is not possible to use any of the above-mentioned interfaces on the front or the
8HP expansion and on the rear I/O simultaneously.
ID 1042-9252, Rev. 2.0
Installation
Page 3 - 11