Table of Contents
Advertisement
CP3002
2.11.3
USB Interfaces
The CP3002 supports six USB 2.0 ports: two on front I/O, two on the high-speed I/O extension
connector J12, two on the rear I/O CompactPCI connector J2. All six ports are high-speed, full-
speed, and low-speed capable.
One USB peripheral may be connected to each port. For connecting more USB devices to the
CP3002 than there are available ports, an external USB hub is required.
Note ...
When connecting peripheral devices to USB2.0 ports, always ensure that
appropriate cables are used.
2.11.3.1
Front Panel USB Connectors J9 and J10
The CP3002 has two USB 2.0 interfaces that are implemented as two 4-pin, type A USB connec-
tors on the front panel, J9 and J10, with the following pinout:
Figure 2-1: USB Connectors
J9 and J10
J9
4
3
J10
4
3
Note ...
The CP3002 host interfaces can be used with maximum 500 mA continuous
load current as specified in the Universal Serial Bus Specification, Revision
2.0. Short-circuit protection is provided. All the signal lines are EMI-filtered.
2.11.4
Integrated Graphics Controller
The processor includes a highly integrated graphics accelerator delivering high performance
3D, 2D graphics capabilities. The integrated graphics controller has two independent display
pipes allowing for support of two independent display screens.
Integrated 2D/3D graphics:
• Intel® Dynamic Video Memory Technology
• Intel® Graphics Performance Modulation Technology
• Intel® Smart 2D Display Technology
• High-performance MPEG-2 decoding
• WMV9/VC1 Hardware acceleration
• Support of DisplayPort interface
• Analog display support for resolution up to 2048 x 1536 pixels @ 75 Hz
• Digital display support for resolution up to 2560 x 1600 pixels @ 60 Hz
ID 1042-9252, Rev. 2.0
Table 2-8:
PIN
2
1
2
1
Functional Description
USB Connectors J9 and J10 Pinout
SIGNAL
1
VCC
2
USB-
3
USB+
4
GND
FUNCTION
VCC
Differential USB-
Differential USB+
GND
Page 2 - 11
I/O
O
I/O
I/O
--
Advertisement
Chapters
Table of Contents
