Serial Ata Interfaces; Sata Connectors J5 And J6 - Kontron CP3002 User Manual

CP-RIO3-04 Rear I/O
B.5.6

Serial ATA Interfaces

The onboard Serial ATA connectors J5 and J6 allow the connection of standard HDDs and oth-
er Serial ATA devices to the CP-RIO3-04 rear I/O module.
The following figure and table provide pinout information for the SATA connectors J5 and J6.
Figure B-10: SATA Con. J5 and J6
7 1
J5
Note ...
When using a Serial ATA cable, it is recommended to use a special right-angled
Serial ATA cable due to possible space limitations within the system. For further
information, please contact Kontron.
Page B - 12
Table B-8: SATA Connectors J5 and J6 Pinout
PIN
7 1
J6
SIGNAL
1 GND Ground signal
2 SATA_TX+ Differential Transmit +
3 SATA_TX- Differential Transmit -
4 GND Ground signal
5 SATA_RX- Differential Receive -
6 SATA_RX+ Differential Receive +
7 GND Ground signal
CP3002
DESCRIPTION I/O
--
O
O
--
--
ID 1042-9252, Rev. 2.0
I
I