Board-Specific Information - Kontron CP3002 User Manual

Introduction
1.2

Board-Specific Information

The CP3002 is a CompactPCI single-board computer based on the Intel® Core™ i7 and the
Intel® Celeron processor and specifically designed for use in highly integrated platforms with
solid mechanical interfacing for a wide range of industrial environment applications.
Some of the CP3002's outstanding features are:
• Support for the following multi-chip package (MCP) processors:
• Intel® Core™ i7-610E (SV), 2.53 GHz, 4 MB L3 cache
• Intel® Core™ i7-620LE (LV), 2.0 GHz, 4 MB L3 cache
• Intel® Core™ i7-660UE (ULV), 1.33 GHz, 4 MB L3 cache
• Intel® Celeron® U3405 (ULV), 1.07 GHz, 2 MB L3 cache
• Intel® QM57 Express chipset
• Up to 8 GB, dual-channel, DDR3 SDRAM memory with ECC running at 1066 MHz
• Integrated 3D high-performance graphics controller
• VGA display support for up to QXGA (2048 x 1536 pixels) resolution
• Two Gigabit Ethernet controllers with Wake-on-LAN support (Intel® 82574L), switchable
to rear I/O
• Six Serial ATA (SATA) interfaces with SATA RAID 0/1/5/10 support:
• One SATA interface for the standard SATA onboard connector
• One SATA interface for the Serial ATA Flash module (SSD)
• Two SATA interfaces for the high-speed I/O extension connector
• Two SATA interfaces for rear I/O
• Six USB ports:
• Two USB 2.0 on front I/O
• Two USB 2.0 on rear I/O
• Two USB 2.0 interfaces for the onboard high-speed I/O extension connector
• 32-bit, 33 MHz PCI CompactPCI interface for support of up to seven peripheral slots
(7x REQ/GNT signals)
• Compatible with CompactPCI Specification PICMG 2.0 Rev. 3.0 and usable in the system
controller slot as well as in a peripheral slot (the PCI interface is isolated in peripheral slot)
• TCG 1.2 compliant Trusted Platform Module (TPM), on request
• Two SPI boot flashes for two separate uEFI BIOS images:
• One standard SPI boot flash
• One recovery SPI boot flash
• Watchdog timer
• Battery-backed real-time clock (RTC)
• Two COM ports:
• COMA either on the 8HP expansion module or on the rear I/O
• COMB on the rear I/O
• Peripheral extension connectors:
• High-speed I/O extension connector
• SPI extension connector
• Rear I/O on the CompactPCI connector J2
• 4HP or 8HP, 3U CompactPCI
• Several rear I/O configurations
• Power-up sequencing and in-rush current optimized design
• Passive heat sink solution for forced airflow cooling
• AMI Aptio®, a uEFI-compliant platform firmware
Page 1 - 4
CP3002
ID 1042-9252, Rev. 2.0