1-2 Basic Operation Flow
The following is the basic operation flow for ZW Series.
Preparation
for measurement
Setting
measurement
items
Setting output
processing
Saving settings
(*1) After you have made or changed settings,
be sure to save the setup data.
All set data will be cleared if you turn the
power OFF without saving the data.
ZW User's Manual
Installation and connection
Install the sensor head.
Default settings for connecting
the sensor head.
Perform a sensor head calibration.
Setting measurement items
Select task(s) from TASK1 to
TASK4, and set measurement
items, including height, thickness
and calculation.
Setting the scaling
Calibrate the display of the
measured value.
Setting the hold
Set the hold conditions.
Setting the Zero Reset
Set the Zero Reset.
Saving the setting data (*1)
Save the set data.
Section 2
Installation and Connections
Section 2 Installation and Connections
Section 4 Settings for Functions
4-2
Setting Measurement Items
Section 4 Settings for Functions
4-3
Setting the Output Conditions
Section 4 Settings for Functions
4-3 Setting the Output Conditions
Section 4 Settings for Functions
4-3 Setting the Output Conditions
Section 3 Basic Operation
3-7 Saving a Project
Basic Operation Flow
17