Omron ZW-C1*T User Manual page 98

Hold clearing conditions
Held values can be cleared by the following operation.
• When FUN (adjustment) mode/RUN (operation) mode is switched
• When hold RESET is entered (20-pole terminal block,
• Hold RESET command is entered.
(Example) Peak
The mode is switched between
the FUN mode and RUN mode
FUN mode
Clamp level
(Example) Auto Peak
The mode is switched between
the FUN mode and RUN mode
FUN mode
Clamp level
Important
If an abnormal measured value is obtained during sampling, the hold value is cleared. To not clear the hold value even
if an abnormal measured value is obtained, set "KEEP" as the non-measurement setting.
Setting operation when measurement is not possible p.150
96
Setting the Output Conditions
RUN mode
When RESET is executed
(20-pole terminal block/key input/command).
Sampling
Sampling
RUN mode
When RESET is executed
(20-pole terminal block/key input/command).
key)
When the hold value is reset,
the clamp level is output until
the next hold value is applied.
Hold value
Measurement
value
Hold value
Measurement
value
ZW User's Manual