Omron ZW-C1*T User Manual page 241

Setting the Differentiation Filter
Setting the Differentiation Filter p.93
As an example, here is an explanation of the procedure for selecting the "10ms" number of differential cycles.
Operating procedure
Steps Key operation
1 to 4 For moving to "FILTER", see steps 1 to 4 in p.236.
5
6
7
8
ZW User's Manual
Display Description
Select "DIFFER" as the filter type.
Press the
key.
Enable the differentiation filter.
The current setting value is displayed on the sub-display.
Press
Select "ON", then press the
Set the number of differential cycles.
"CYCLE" is displayed on the main display and the current setting
value is displayed on the sub-display.
Press
blinks.
To edit numerical values, use the
In this example, input "10", then press the
Press the
/ keys to select "DIFFER" and press the
/ key to enter editing mode and the sub-display blinks.
key.
key to enter the editing mode, and the sub-display
/
key for two seconds to enter the RUN mode.
Setting the Output Conditions
/ / keys.
key.
239