Settings For Binary Output - Omron ZW-C1*T User Manual

Settings for Binary Output

The following describes the settings for outputting the current measurement results and judgment values from
the binary output of the 52-pole extended connector.
Output content setting
Sets the output content for binary output.
Item Setting item
Binary output Output object
Output format
When the measured value is output
Outputs the measured value as a 21-bit binary number (2's complement).
(Example1)
When the measured value is "+1.23456" (The number of digits after the decimal point is the default (5 digits).)
123456 (decimal) 000011110001001000000 (binary)
(Example2)
When the measured value is "-1.23456"
-123456 (decimal) 111100001110111000000 (binary)
Note
When multiple tasks are output continuously, the currently output task number is output in the BINARY_OUT output.
Binary output task number output p.136
When the judgment is output
b20 b19 b18
146
Parallel I/O connection
Setting value
Off
(Default value)
Measurement value 1
Measurement value 2
Judgment value
b17 b16
b15 b14 b13 b12
Bit
b0/3/6
b1/4/7
b2/5/8
Description
No binary output.
Sets whether or not there is output for each task.
The measured value for the task selected here is output as
binary for each measurement cycle.
The measured value for the task selected with the
BINARY_SEL input (See p.136) is output.
Outputs the judgment result.
b11 b10 b9 b8 b7 b6
TASK4
Judgment
result
Item
HIGH Turns ON when the judgment result is HIGH.
Turns ON when the judgment result is PASS.
PASS
LOW Turns ON when the judgment result is LOW.
b5 b4 b3 b2 b1 b0
TASK3 TASK2
Judgment Judgment
result result
b2 b1
b0
HIGH
LOW PASS
Details
ZW User's Manual