Performing The Update On Warp Engine Zw - Omron ZW-C1*T User Manual

3
Check the content of the message, and click
[OK].
The firmware update is started.
A progress bar is displayed during update
processing. Wait for the [Firmware Write
Completed] popup to be displayed. (The update
takes several minutes to complete.)
Important
• Errors may occur on the Sensor Controller
during updating, but just wait for the update to
complete.
• If the update progress bar stops midway or the
update does not end even after ten minutes,
there is the possibility that the update has failed.
In this case, contact an OMRON branch or sales
office about the firmware version before update
and the firmware version in the write file.
4
Click [Close].
The firmware update is completed.

Performing the Update on Warp Engine ZW

Warp Engine ZW is automatically installed when Smart Monitor ZW is installed. For details on the Smart
Monitor ZW, refer to the Smart Monitor ZW Operation manual (Cat. No.Z323).
Before proceeding with this operation, connect the ZW to the personal computer where Warp Engine ZW is
installed using an Ethernet cable.
Important
• Only start Warp Engine ZW when the computer has recognized the Sensor Controller normally.
• Do not change the IP address and the subnet mask when using Warp Engine ZW on the same personal computer
with which SmartMonitor ZW is used. If you are using a different personal computer, refer to p.170 and change the
IP address and the subnet mask of the Sensor Controller.
ZW User's Manual
305
Firmware update