Omron ZW-C1*T User Manual page 43

Class Name
Parallel HIGH output
output
PASS output
LOW output
ALARM output
BUSY output
ENABLE output
Parallel ZERO input
input
RESET input
TIMING input
LED OFF input
Analog OUT1 (V)
output
OUT1 (A)
OUT1 0V
Power Sup- 24 VDC (+)
ply
24 VDC (-)
1
Loosen the two fixing screws using a screwdriver to
remove 20-pole terminal block from the Sensor Con-
troller.
ZW User's Manual
Description
This outputs judgment results - HIGH (HIGH threshold values < Measured value).
This outputs judgment results - PASS (LOW threshold values  Measured value  HIGH
threshold values).
This outputs judgment results - LOW (LOW threshold values > Measured value).
This turns ON when there is a system error.
This turns ON during sampling with the hold function enabled. It allows you to check
whether or not the self-trigger is functioning correctly.
It also turns ON during bank switching.
This turns ON when the sensor is ready for measurement.
This output is interlocked with the ENABLE indicator.
This is used to execute and clear a zero reset.
This resets all executing measurements and outputs.
While a RESET is being input, judgment output conforms to the non-measurement setting.
If this RESET input switches ON while the hold function is used, the state in effect before
the hold function was set will be restored.
This is a signal input from an external device that is used to time the hold function with the
continuous measurement function enabled.
This is a signal input from an external device that is used to time the measurement with the
trigger measurement function enabled.
This LED-OFF signal puts out the measurement LED.
While LED-OFF is being input, the analog output, binary output, and judgment output
conform to the non-measurement setting.
This outputs the measured value, from -10 V to +10 V as the voltage value.
When measurement not possible: Approx. +10.8 V (default value; can be selected by user)
Alarm: Approx. 10.8 V
This outputs the measured value, from 4 mA to 20 mA as the current value.
When measurement not possible: Approx. +21mA (default value; can be selected by user)
Alarm: Approx. +21 mA
0 V for analog voltage output.
Terminal for external power supply (24 V)
Terminal for external power supply (0 V)
fixing screws
(both end)
41
Wiring