Settings For Internal Logging - Omron ZW-C1*T User Manual

Settings for Internal Logging

Set the LOGGING save count and LOGGING save intervals
The following describes the settings for internal logging.
Item Setting item
Internal logging LOGGING save
count
LOGGING save
intervals
Important
• This settings are not applied when internal logging is started by sending No-protocol communications or the
operating keys on the Sensor Controller.
• It cannot set and display using Sysmac Studio.
Note
The setting of LOGGING save count and LOGGING save intervals can also be set by the operating keys on the
Sensor Controller.
Setting for Internal Logging p.275
154
Parallel I/O connection
Setting value Description
0 to 12800 Sets the maximum data count to be internally logged.
(default value)
0 to 1 (default Sets the intervals to be internally logged.
value) to 1000 If "1" is set , all measured data is stored, and "2" is set, one measured data is
stored every two measurement.
If "0" is set, only the applied measured data is stored when hold is set.
ZW User's Manual