Omron ZW-C1*T User Manual page 267

Assigning Analog Output
Assigning Analog Output p.139
As an example, here is an explanation of the procedure for outputting the results of TASK1 as analog.
Operating procedure
Steps Key operation
1 to 3 For moving to "ANALOG", see steps 1 to 3 in p.264.
2
3
4
Setting Monitor Focus
Setting Monitor Focus p.140
The following describes the procedure when setting 4 mA output (Point1) for measured value of 0 mm and 20
mA output for measured value of 6mm (Point2).
Operating procedure
Steps Key operation
1 to 3 For moving to "ANALOG", see steps 1 to 3 in p.264.
4
ZW User's Manual
Display Description
Press the
Select the task to output.
TASK1 to TASK4/OFF
The current setting value is displayed on the sub-display.
Press
In this example, select "TASK1" and press the
Press the
Display Description
Press the
/ keys to select "OUTPUT" and press the
/ key to enter editing mode and the sub-display blinks.
key for two seconds to enter the RUN mode.
/ keys to select "FOCUS" and press the
key.
key.
key.
Connecting Parallel I/O
265