3-8 Performing internal logging
Up to 2000000 data of measurement values can be logged in the Sensor Controller's internal memory.
Internal logging can be started or ended using Sysmac Studio, parallel I/O, or non-procedural communications
commands.
The operating procedures for each method are shown below.
Function
Specify start timing
Specify end timing
Output logging data
Clear logging data
The settings that can be enabled for each method are shown below.
Function
Overwrite mode
Label insert mode
Output data format
Internal logging by Sysmac Studio
Data logging conditions and logging start/end timing can be set with Sysmac Studio.
Multi view Explore
→ Edit pane
→ Online setting window : [Internal Logging]
1
Set the logging conditions.
Enter the [Data interval], [Number of logging
data], and select the stored output data.
106
Performing internal logging
Sysmac Studio
Press the "Logging Start" button.
Stops automatically after the specified
number of logging data has been saved.
Press the "Save to file (Sensor → PC)"
button.
Cleared automatically after the "Logging
Start" button is pressed.
Sysmac Studio
OFF
OFF
ASCII
: [(ZW model name)] (double click)
: [Online] icon (
Parallel I/O
LOGGING input ON
LOGGING input OFF
Send LO/LG
command
Send LC command
Parallel I/O
ON/OFF
ON/OFF
ASCII/Binary
)
Non-procedural commu-
nications commands
Send LS command
Send LE command
Send LO/LG command
Send LC command
Non-procedural commu-
nications commands
ON/OFF
ON/OFF
ASCII/Binary
ZW-7000/5000
User's Manual