Dukane iq series User Manual page 89

System Status I/O Sub-menu Items
The five sub-menu items and their corresponding displays
(Figure 5-65) are shown below:
1) Auto Start Input
Solid State, or
Mechanical - If this is chosen, a value (0.000 to
0.100 seconds) must be given for Debounce.
2) Auto Stop Input
Choose to Disable this, or select End of Weld, or
End of Cycle.
3) J3 Pin 4
Choose the output signal for J3 Pin 4:
E-Stop, or Overtemp
4) J3 Pin 5
Choose the output signal for J3 Pin 5:
Hold, In Cycle, or In Cycle No AB
5) Output Duration
Choose either Maintained, or 100mS Pulse.
Moving to the Next Sub-menu
When > is next to OUTPUT DURATION, and the down
key (minus) is pressed, the next sub-menu for MISCEL-
LANEOUS replaces the SYSTEM STATUS IO sub-
menu.
Dukane Manual Part No. 403-586-02
Continued from Previous Page
SOLID
STATE
MECHANICAL
DISABLED
END OF
WELD
END OF
CYCLE
E-STOP
OVERTEMP
HOLD
IN
CYCLE
IN CYCLE
NO AB
MAINTAINED
100 ms
PULSE
Figure 5-65 System Status I/O Sub-menu Items
Section 5 - Operation
SYSTEM STATUS I/O
>
AUTO START INPUT
AUTO STOP INPUT END OF CYCLE
J3 PIN 4
J3 PIN 5
OUTPUT DURATION
SYSTEM STATUS I/O
AUTO START INPUT
AUTO STOP INPUT END OF CYCLE
>
J3 PIN 4
J3 PIN 5
OUTPUT DURATION
SYSTEM STATUS I/O
AUTO START INPUT
AUTO STOP INPUT
>
J3 PIN 4
J3 PIN 5
OUTPUT DURATION
SYSTEM STATUS I/O
AUTO START INPUT
AUTO STOP INPUT
J3 PIN 4
J3 PIN 5
>
OUTPUT DURATION
SYSTEM STATUS I/O
AUTO START INPUT
AUTO STOP INPUT END OF CYCLE
J3 PIN 4
J3 PIN 5
>
OUTPUT DURATION
ONLINE
SOLID STATE
E-STOP
HOLD
MAINTAINED
ONLINE
SOLID STATE
E-STOP
HOLD
MAINTAINED
ONLINE
SOLID STATE
END OF CYCLE
E-STOP
HOLD
MAINTAINED
ONLINE
SOLID STATE
END OF CYCLE
E-STOP
HOLD
MAINTAINED
ONLINE
SOLID STATE
E-STOP
HOLD
MAINTAINED
Page 81