Press Ergonomic Base; Thruster Indicators - Dukane iq series User Manual

iQ
Series Ultrasonic Press System LE User's Manual

Thruster Indicators

Pressure Gauge
The pressure gauge shows the amount of air pressure ap-
plied to the upper portion of the air cylinder for the weld-
and-hold operation.
Ultrasound Active Status Light
This LED indicator lights up when the generator is apply-
ing ultrasonic power to the horn.
Stroke Position Indicator Flag
The stroke position indicator flag is not preset prior to
press operation. It moves with the slide assembly as the
assembly moves down and up.
Mechanical Stop Indicator Flag
This setting indicates where the downstroke will end.
Slow Speed Indicator Flag (Optional)
This indicator flag is set by the Slow Speed Control. It is
included as part of the Slow Speed Control option. When
set, it indicates the point in the downstroke where the
plunger on the hydraulic speed control is engaged.

Press Ergonomic Base

The ergonomic base, shown in Figure 4-12, consists of a
base plate, cycle activation switches (black finger switch-
es), abort switch (red palm switch), and a status display
screen. At the back of the base is a cable connector for an
interface between the iQ Series generator and the base
front panel.
Base Plate
The machined base plate is bolted to the top of the ergo-
nomic base. It has drilled and tapped holes that line up
with leveling screws in the fixtures to allow easy fixture
leveling for alignment with the horn. For details on the
alignment and leveling of the base plate, see Section 7:
Stack/Fixture Setup.
Page 50
Continued from Previous Page
Operate
Switch
Figure 4-12
e t
wer i t re
wer i t re
St p Switc h
Ergonomic Base Controls
Dukane Manual Part No. 403-586-02
Right
Operate
Switch