System Power Output Level; Power On Light - Dukane iq series User Manual

System Power Output Level

(Bar Graph)
A bar graph displays the percentage of ultrasonic power
being drawn by the load. See Figure 4-7 to the right.
Peak Detect Feature
To indicate the maximum peak power achieved during a
weld cycle, the segment in the bar graph corresponding
to the peak level remains on (for about one second) after
the weld cycle has been completed.
Flash on Overload at 90%
The indicator begins to flash when the gen-
OVERLOAD
erator produces 90% of the overload power rating. This
feature alerts the operator to an impending overload fault
condition.
Bar Graph Power Scaling
Power scaling is related to amplitude. At 100% amplitude
the whole graph is lit, and the generator is operating at
100% power. At 50% amplitude the entire graph is lit, and
the generator is operating at 50% power.
If the amplitude setting is lowered, the graph rescales
automatically according to the revised amplitude.
Example: With a 1200W generator, at 50% amplitude, if
the whole graph is lit, that represents 600W.

Power On Light

This front panel light glows after the rear panel AC power
switch/circuit breaker is turned ON:
On start-up, the light flashes RED for a few seconds, and
then turns steady GREEN. This indicates AC power has
activated the generator.
When the AC power switch is turned to the OFF position,
the front panel light goes out indicating the generator no
longer has power.
Dukane Manual Part No. 403-586-02
AUTO 01 SETUP #01
PART COUNT:
WELD TIME :
ENERGY:
PEAK POWER :
DISTANCE
PROCESS
STATISTICS
Figure 4-7
Go to Section 5 - Operation, Start-up
Sequence for an explanation of the
generator start-up sequence.
System Power Output Level
Bar Graph
ONLINE
0
0.000s
0J
0 W
0in
Display Detail, Power Output Level
CAUTION
If the System Output Power
Level red overload indicator
is lit, that means there is an
overload fault. If this hap-
pens, verify that the ultrasonic stack
is not damaged.
NOTE
Section 4 - Controls
Page 43