Dukane iq series User Manual page 103

Alignment
7. Set the gap between the encoder scale and head, using
the feeler gauge .039 inch (1 mm) blade.
8. Measure the gap at the top and bottom of the stroke.
Allowable tolerance, as specified by the encoder
manufacturer, is ±.005. This is a range of from .034
to .044 inches (.864 to 1.12 mm).
9. Tighten all the screws and check the measurements
again.
10. Replace the press/thruster right side panel.
Dukane Manual Part No. 403-586-02
Continued from Previous Page
Section 6 - Options
Page 95