iQ
Series Ultrasonic Press System LE User's Manual
For all menus - When a button is pressed to access the menu, the last access
parameter will be selected and ready to change if applicable.
Example: If the PRE WELD button is pressed, and the Trigger Distance value
was the setting last accessed in that menu, then Trigger Distance is highlighted
and ready to change.
On screen Prompts - Watch for and follow on screen prompts where they appear.
Example: In Figure 5-4 below the prompts are:
PRESS ENTER TO ACCEPT, or PRESS CANCEL TO ABORT
AMP
The menu in Figure 5-4 is the default display showing
WELD with its amplitude value ready to be changed.
This is the only menu available if MODE is set to AUTO-
MATED PROBE.
This same menu is displayed if MODE is set to iQ CON-
TROLLED PROBE MODE, and TRIGGER BY POWER
is disabled, or if PRE-TRIGGER is disabled in either of
the press modes.
If iQ CONTROLLED PROBE MODE is selected, and
AFTERBURST is enabled in the POST WELD menu,
then the AFTERBURST soft key is also displayed as
shown in Figure 5-5 to the right. The parameter value last
accessed will be highlighted and ready to change.
Page 58
Continued from Previous Page
NOTE
NOTE
Figure 5-4
Figure 5-5
AMPLITUDE
WELD
PRE
POST
AMP
WELD
WELD
WELD
Setting Weld Amplitude
AMPLITUDE
WELD
AFTERBURST
PRE
POST
AMP
WELD
WELD
WELD
Setting Weld Amplitude with Afterburst
Enabled
Dukane Manual Part No. 403-586-02
ONLINE
100%
PRESS ENTER TO ACCEPT
PRESS CANCEL TO ABORT
LIMITS
LIVE
SETUPS
OPERATE
ONLINE
100%
PRESS ENTER TO ACCEPT
PRESS CANCEL TO ABORT
LIMITS
LIVE
SETUPS
OPERATE
Continued