Stopping The Weld Cycle - Dukane iq series User Manual

iQ
Series Ultrasonic Press System LE User's Manual

Stopping the Weld Cycle

Normal Conditions
The cycle stops when the programmed welding cycle ends
Emergency Conditions
Manual System
Do either of these things:
1) Press the OFFLINE front panel key to stop the ultra-
sound signal. This may be done under any condition,
OR
2) If the generator's front panel power light is on, move
the rear panel AC breaker switch to the OFF position,
and the front panel power light goes out.
Automated System
Customer-supplied external controls provide the means to
stop the cycle for an automated system.
An auxiliary cable connects these external controls to the
iQ generator at connector J2.
Control input labeled, "Automation Cycle Stop Input" (Pin
15) when activated will stop the weld cycle if configured
as "End of Weld".
Page 56
.
Dukane Manual Part No. 403-586-02