Connecting Generator Cables - Dukane iq series User Manual

iQ
Series Ultrasonic Press System LE User's Manual

Connecting Generator Cables

Step 1. Ground the generator chassis with the
supplied 14-Gauge wire, and attach it to the
grounding stud. See Figure 3-6.
Step 2. Ultrasound (J1) - This output connects the Ul-
trasound Output of the iQ Series generator to the
transducer, through a coaxial cable. The electrical
welding signal is transmitted through this cable.
Step 3. Operational Control (J201) - This cable runs from
J201 on the thruster to the generator's Thruster
connector (J5). The generator provides controls
for triggering the weld, operating the thruster's
pneumatic system, and providing 24 VDC oper-
ating voltage through this cable. The press driver
card in the generator also provides monitoring for
these functions.
Step 4. Base/Abort Cable (J6) - Connects to the press
base plate connector (J35) or an automation PLC.
Step 5. Connect the AC power cord to the IEC power
inlet connector on the ultrasonic generator, and
plug the other end into an approved AC outlet.
Power Cords
The AC line cords supplied with the standard generators
are matched to the ultrasonic output power rating and the
continent of specified use. See Table 3-IV.
Page 28
The power cord is equipped
with a three-prong, ground-
ed-type plug for your
safety. Whenever a two-
slot receptacle is encountered, we
strongly recommend that it is replaced
with a properly grounded three-lead
receptacle.
Have a qualified electrician do the
replacement in accordance with the
National Electrical Code and local
codes and ordinances. DO NOT cut
off the power cord grounding prong or
alter the plug in any way.
Continent of Use
North America
Continental Europe
Table 3-IV Power Cords
Dukane Manual Part No. 403-586-02
CAUTION
Power Cord Power
Part Number
200 - 1110 240V, 15A
200 - 1541 240V, 10A
200 - 1111 240V, 16A
200 - 1542 240V, 10A