Stopping The Weld Cycle - Dukane i220 User Manual

iQ Series
Ultrasonic Integrated Press System i 220 User's Manual

Stopping the Weld Cycle

Normal Conditions
The cycle stops when the programmed welding cycle ends
Emergency Conditions
Manual System
Do one of these things:
1) Press the red Emergency Off (E-STOP) switch (also
called the Abort switch.) located on the press base.
2) Press the OFFLINE front panel key to stop the ultra-
sound signal. This may be done under any condition.
OR,
3) If the press front panel power light is on (GREEN),
move the rear panel AC breaker switch to the OFF
position. The front panel power light will go out as
power is cut off.
Automated System
Customer-supplied external controls provide the means to
stop the cycle for an automated system.
The 200-1546-xxM cable can be used to connect these
external controls to the I/O panel at connector J6.
See Page 30 for more information.
Page 50
.
Dukane Manual Part No. 403-594-02