System Power Output Level - Dukane i220 User Manual

System Power Output Level

(Bar Graph)
A bar graph displays the percentage of ultrasonic power
being drawn by the load. See Figure 4-7 to the right.
Peak Detect Feature
To indicate the maximum peak power achieved during a
weld cycle, the segment in the bar graph corresponding
to the peak level remains on (for about one second) after
the weld cycle has been completed.
Bar Graph Power Scaling
Power scaling is related to amplitude. At 100% amplitude
the whole graph is lit, and the press is operating at 100%
power. At 50% amplitude the entire graph is lit, and the
press is operating at 50% power.
If the amplitude setting is lowered, the graph rescales
automatically according to the revised amplitude.
Example: With a 1200W press, at 50% amplitude, if the
whole graph is lit, that represents 600W.
Power LED
The front panel POWER
AC power switch/circuit breaker is turned ON:
On start-up, the light flashes GREEN for a few seconds,
and then turns steady GREEN. This indicates AC power
has activated the press.
When the AC power switch is turned to the OFF position,
the front panel POWER
no longer has power.
Dukane Manual Part No. 403-594-02
AUTO 01
PROCESS
STATISTICS
glows after the rear panel
LED
goes out indicating the press
LED
SETUP #01
PART COUNT:
WELD TIME :
ENERGY:
PEAK POWER :
DISTANCE
Figure 4-7 Display Detail, Power Output Level
If there is an overload fault
verify that the ultrasonic stack
is not damaged.
Go to Section 5 - Operation, Start-up
Sequence for an explanation of the
press start-up sequence.
Section 4 - Controls
System Power Output Level
Bar Graph
ONLINE
0
0.000s
0J
0 W
0in
CAUTION
NOTE
Page 39